1 This series of steps should be done after painting or staining and finishing of the guitar body.

2 The first thing to do for your electronics is to get a thin sheet of

brass from a local hobby shop and cut, bend and shape it to fit the bottom and sides of your electronics cavity(I know you thought I was done using that word didn’t you!). Now hook in all your pods and pull your wires into the cavity. Then solder the wires according to the wiring guide here (make sure to be careful and

take your time, I know you excited to play your new tow, so don’t break it first):

A quick reminder not to forget to install the string nut at the end of your fretboard (if you wish to make your own get the book already)!

Where:
P=Pickup     C=Compascitor     T=Tone Control Pot     V=Volume Control Pot     G=Ground     H=Hot